How to Install the new igniter - Heanjia Super-metals Co., Ltd.

Nichrome News

How to Install the new igniter

If your gas oven starts showing problems, it may be due to improper functioning of your oven igniter. The igniter basically consists of nichrome resistance wire to produce adequate amount of heat to bake the food. This article describes the detailed instructions on how to install the new igniter to make it perform properly.

There are several equipment brands introduced in the market with variable designs. The customer should be cautious in identifying the difference between the body shapes of different brands of ovens. Each igniter follows the same process of heat generation though the user must take care of the installation and separation of the device to get the task done properly.

The igniting device is designed in the circular or flat shape on the base of model. The shapes should never be messed up that if you used round shape igniter earlier, you should buy the round shape igniter only. However if you had a flat shape igniter earlier, opt with the same only. But if you are uncertain on which igniting device to use, in such case you should get the parts diagram for the particular oven and receive the proper device.

Over the various equipments in the different brands the internal oven space can be accessed without the need to remove the door. If you prefer to remove door for convenient access, you should follow the manufacturing guide to learn how to remove the door. There are several brands that provide convenient access to the door. In different models the door can open partly and tenderly pull up on door to slide of the hinges. However various other brand ovens allow opening the full door, the inferior hinge clips, the door shuts partly and side it off the hinges.

The indoor edge panel of the oven's open space needs to remove at the backside of the edge panel. Get the backside of panel by vent opening and drag and up to the removal panel. It will show you the igniter.

Eradicate the below drawer to get access to igniting device terminals of nichrome wire. Simply detach these wires from the valves and harness. Dissemble the burner and find the screw holding in the front side of the burner of inside oven. Removing the drawer, show you the screws in the lower side of burner vessel and eradicate the burner vessel.

Then remove the double screws protecting the igniter and replace it with the new igniting device. A valuable technique to remove the double oxidized screws is to place a dab of liquid soap on every string prior to remove the igniting device.The plug and terminals of the old igniters can be reused. Cut down each end by three to four inch and join the new igniter wires using the porcelain wire nuts. Install the nichrome wire back to the device and put the large wire potion behind the panel or gas vessel. Also replace the edge panel of oven.

Pre Page: Techniques to make igniter using... Next Page: Different Types of heating wires and...

Product (745)

Product Forms (14)

Quality Certificate (11)

Learning Gallery (30)

Incoloy News (9)

Inconel News (22)

Molybdenum News (7)

Nikrothal News (4)

Nichrome News (13)

Titanium News (2)

Nickel News (8)

Alloys House (30)

Tools (27)

Nickel alloy News (30)

Latest Buzz (30)

nickel chrome copper iron alloys news (28)

Credit Report

Products Index

Company Info

Nichrome News